How To Use the Machine 11 Apr 2018

Roll forming machine can help you to create complex joints and flanges in sheet metal. For the machine to give you the results you deserve, you should know how to use it properly. Below are instructions on how to properly use the machine:

You should start by loosening the nuts that hold the guard onto the top of the Metal Roll Forming Machines. To do this you need to place the socket that matches the guard bolts onto the 3/8-inch drive ratchet. You should lift the guard up in order to remove it from the top of the roll former.

To remove metal shavings and any debris that might be in the rolls, you should blow the area between the rolls using an air hose. You should also spray the rolls with cool air and lubrication. This is to prevent the Roof Ridge Cap Roll Forming Machine.

Roof Ridge Cap Roll Forming Machine

Once everything is in place you should slide the guard back over the studs and tighten the bolts that you had loosened. You should inspect the guard and ensure that no part of the guard falls into the feed area of the machine.

You should now start the machine and slide the side of the metal (that you want to roll) towards the starting guide. You should continue supporting the metal sheet as its being grabbed by the Roll Forming Machine .

When metal is rolled up and pop-up on the other side, you should check to make sure the gap is correct. If the joints malformed or stuck, rolls should be adjusted. If you want to know more information, please visit: rollformingmachinerychina.com.

categories
hotproducts
   
chat now chat now
If you have questions or suggestions,please leave us a message,we will reply you as soon as we can!